KIT ATCONTROL/R
Self-configurable self-reclosing permanent and transient overvoltage protector for power supply lines.
Technical data
- KIT ATCONTROL/R protectors actuate when they detect a permanent overvoltage by tripping the connected contactor (normally open) (S1, S2). This contactor disconnects the line, thus protecting any equipment installed downstream. When the permanent overvoltage comes to a halt, the protector reconnects the contactor.
- The warning system for permanent overvoltages consists of two luminous indicators: green (correct power supply) and red (overvoltage). It has a test button to check that installation has been executed correctly.
- KIT ATCONTROL/R PT protectors also actuate when they detect a transient overvoltage, diverting the current to earth and reducing the voltage to a level that does not damage the connected equipment.
- Tested and certified as a type 2 protector in official and independent laboratories according to standards UNE-EN 61643-11 and GUÍA-BT-23 from the REBT. Appropriate for category I, II, III and IV equipment according to REBT (ITC-BT-23).
- It has a thermodynamic control device that disconnects from the electrical network in case of deterioration, and also a warning system for transient overvoltages. When the warning is yellow, the protector is in good condition. If not, replace.
- KIT ATCONTROL/R series protectors have been tested in official, independent laboratories obtaining their characteristics according to applicable standards.
Selection filters: Select product resources
List of products according to your selection
| Reference | Name |
|---|